Before you start
- Enable VISCA over IP in the camera’s network settings, if it isn’t on by default.
- Check the Collector can reach the camera on UDP 52381.
Add the device
- In the portal, go to Devices and select New device.
- Choose the Collector that can reach the device, and set Protocol to VISCA-over-IP (PTZ cameras).
- Enter the settings below and save. The Collector picks up the new device within seconds.
Readings
These values appear under Device Information on the device page, and can be checked in Room Readiness routines.Commands
Each command is a button on the device page, and can be used in Room Readiness routines.Updated 23 Oct 2026 15:20 · page 6429a85