Skip to main content
Works with: Sony Bravia Professional Displays with IP control.

Before you start

  1. On the display, open Settings → Network → Home network setup → IP control.
  2. Set Authentication to Normal and Pre-Shared Key and enter a pre-shared key. You’ll use it as the device’s password.
  3. Turn on Remote start so the display can be powered on over the network from standby.

Add the device

  1. In the portal, go to Devices and select New device.
  2. Choose the Collector that can reach the device, and set Protocol to Sony Bravia Professional.
  3. Enter the settings below and save. The Collector picks up the new device within seconds.
Tags are set in the Tags section of the device form: select Add tag, then enter the name and value, for example mac_address = AA:BB:CC:11:22:33.

Readings

These values appear under Device Information on the device page, and can be checked in Room Readiness routines.

Commands

Each command is a button on the device page, and can be used in Room Readiness routines.
Power-on: M.A.R.C.U.S. sends a Wake-on-LAN packet straight to the display’s address, then the IP-control power command. The display’s MAC address is learned automatically the first time it’s reached while switched on; set the mac_address tag if you need power-on to work before that.
Firmware: the display’s software version shows as Firmware Version (such as PKG6.5603.0175), with its Android version and Pro mode, and appears on the Firmware page. Older displays that don’t report it show model and serial only. It’s read when the display is first reached and every six hours after.

Updated 06 Nov 2026 14:07 · page 8c47700