Skip to main content
Works with: NEC and Sharp NEC projectors that support NEC’s projector control commands over the network, including the PA-series laser models such as the NP-PA804UL and NP-PA1004UL.

Before you start

  1. Connect the projector’s LAN port to the network and note its IP address. Control commands use TCP port 7142.
  2. So that the projector can be monitored and switched on while in standby, set its Standby Mode to Normal or Network Standby, not a power-saving mode that turns the network off.
  3. If Control ID is turned on in the projector’s menu, set the control_id tag to the same number.

Add the device

  1. In the portal, go to Devices and select New device.
  2. Choose the Collector that can reach the device, and set Protocol to NEC projector.
  3. Enter the settings below and save. The Collector picks up the new device within seconds.
Tags are set in the Tags section of the device form: select Add tag, then enter the name and value, for example control_id = 1.

Readings

These values appear under Device Information on the device page, and can be checked in Room Readiness routines.

Commands

Each command is a button on the device page, and can be used in Room Readiness routines.
Warming up and cooling down: the projector accepts no other commands while it powers on or cools down. Power Status shows warming or cooling during that time, and a command sent then fails with a message saying so. Power On during cool-down is refused until cooling has finished.
Standby: in standby the projector reports its power state, light-source and filter hours, faults and identity; input, mute and volume readings return when it’s switched on.
One connection: the Collector connects only for each poll or command, so a room control system can use the projector’s control port in between.
Firmware: NEC’s control commands don’t report a firmware version, so these projectors don’t appear on the Firmware page.

Updated 10 Nov 2026 13:55 · page bae9202