Skip to main content
Works with: Cisco TelePresence codecs running TC software (TC7.x), including the SX, MX, EX, C and Profile series. For CE or RoomOS software, use Cisco RoomOS.

Before you start

  1. Check the codec’s software version in its web interface, under System Information. It starts TC7 for this adapter.
  2. Note the username and password of a user with the Admin role. On TC, the built-in admin user has it.
  3. TC uses a self-signed certificate unless you’ve installed your own. If you haven’t, set the tls_skip_verify tag to true on the device.

Add the device

  1. In the portal, go to Devices and select New device.
  2. Choose the Collector that can reach the device, and set Protocol to Cisco TC (TC7).
  3. Enter the settings below and save. The Collector picks up the new device within seconds.
Tags are set in the Tags section of the device form: select Add tag, then enter the name and value, for example tls_skip_verify = true.

Readings

These values appear under Device Information on the device page, and can be checked in Room Readiness routines.

Commands

Each command is a button on the device page, and can be used in Room Readiness routines.
Older HTTPS: TC’s web server predates current TLS, so this adapter also accepts TLS 1.0 and 1.1 and older cipher suites. TC enables HTTP as well as HTTPS by default; if HTTPS still won’t connect, enter the address as http:// followed by the codec’s IP address.
Power: Power Off puts the codec into standby and Power On wakes it. The device page shows the standby state as Off (awake) or Standby.
Not available on TC: people count, which needs RoomOS.

Updated 06 Nov 2026 14:07 · page a16abd7